Vesconite has been most successfully used as bearings for large main cooling water, vertical spindle mixed flow pumps in a New Zealand power station.

The pumps at the power station were fitted with cutlass rubber in-line shaft bearings when the pumps were installed in 1977.

In line shaft bearings :

5 Off per pump. 230 x 180 – 280 mm long with 12 longitudinal grooves.

Shaft sleeve material : 316 L stainless steel.

The pumps had operated successfully for 20 years when they needed to be refurbished.

At this point Vesconite bearings were installed rather that the originally designed rubber in a bronze sleeve. The grooving design of the Vesconite bearing was similar to the rubber groove design.

Date Vesconite bearings installed - March 2000

The reason for change of material was that the utility required a material that would perform as well as the rubber had, but the material needed to be readily available.

In many cases large diameter rubber bearings have to be specially manufactured to order. In contrast, ready to machine Vesconite bushing stocks are kept in many worldwide centers. Stock material or finished machined items can be quickly sent by courier from the manufacturer if required.

When Vesconite bearings replace metal backed bearings, the bearing and shell are removed and replaced with Vesconite. The interference fit on Vesconite is easily overcome with press or freeze fitting the bearing. Vesconite can also be installed into machined out metal housings.

At this power station, a further advantage noted is that the installed running clearance was much closer for the Vesconite bearings than was possible with the original cutlass rubber bearings. The benefit is that the impeller does not run on the casing and therefore the pump is more efficient, both in respect of pumping ability and a saving in power consumption.

The reliability of Vesconite make it suited to critical pump bearing applications.